[Top] [Prev] [Next] [Contents] [Index]

Disabling All Remote Configuration File Downloads

NCD terminals are configured initially to download a configuration file. To disable configuration file download, set the config-load-initial-file parameter to "false" (Setup -> Change Setup Parameters -> Configuration [Initial Configuration File section] -> Load Initial File).

Table 6-7 config-load-initial-file Parameter
Possible Values
default true
true The X server attempts to download a remote configuration file.
false The X server does not attempt to download a remote configuration file.

The config-load-initial-file parameter is saved in NVRAM. If you want the new value to take effect the next time the terminal boots, set the parameter interactively (either through Change Setup Parameters or a TELNET connection) and apply the new value.

[Top] [Prev] [Next] [Contents] [Index]

Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights reserved.