Command DLCND
| GSI | Biophysics | display commands |

DLCND

number
anlid
/
cond()
list
clear
debug

Purpose

Specify analyzer conditions that an event must satisfy in order to be displayed in live mode

Parameters

number

Number of the live display for which conditions are to be defined. If only one live display is used, number=1 must be specified.

anlid

Name of the analyzer whose condition is to be used.

cond(c)

Condition number of analyzer 'anlid' which must be satisfied for display. If omitted, an event is displayed when the input condition of analyzer 'anlid' is satisfied, i.e. when the latter has been incremented by that event.

list

List a table of previously defined live display conditions.

clear

Reset previously defined live display conditions.

debug

Debug switch. Lots of output !

Function

Remarks

Live display conditions are derived from analyzer conditions that must be defined and/or set by a previous command like DSWI or ACDEF. DLCND uses but does not alter analyzer conditions.
A maximum of 10 conditions may be specified for each live display.
Conditions for live display mode are not cleared automatically (e.g. after a new DLIVE command is given). To start a live display without conditions, all previously defined live display conditions must be explicitly reset by the command DLCND/CLEAR.

Examples

DLCND 1 DE / COND(3)                                               
DLCND 1 M
In live display no. 1 events are only displayed if condition no. 3 of analyzer DE and the input condition of analyzer M are satisfied. 
DLCND 3 ENERGY / COND(5)
In live display no. 3 events are only displayed if condition no. 5 of analyzer ENERGY is satisfied 
DLCND / list
Write a list of previously defined live display conditions to terminal and protocol. 
DLCND 1 /clear
Clear all live display conditions for live display no. 1.
| GSI | Biophysics | display commands |
Last updated: M.Kraemer@gsi.de, 4-Aug-1999

Impressum Data privacy protection